Typically, but not required, you put all of your plumbing within one wall. Basically this means if you pour a gallon of water down there it's basically the same as flushing the toilet. TIP: Did you know that the drain is basically gravity feed? I guess I didn't really realize this at first. You don't have to dig up the entire line, just enough to add a bend in it and point it to where you want it. In the end I designed what I wanted and had to move the rough-in about 9 inches. My layout just wouldn't work, no matter how many scenarios I tested on paper. The problem was that builder had the bathroom situated a different way. In my case the builder had already included this. When I say "rough-in" I'm talking about the pipe that get's installed before they pour the concrete floor. The biggest stumbling block for me was getting the spacing just right while trying to work around the location of the toilet drain which was already roughed in. Otherwise, make sure you check your code for how far from the shower your toilet needs to be (usually 9 to 14 inches). If you have the space, a separate room for the toilet is a nice touch. I had enough room so I built a closet with a door inside the bathroom. A sink with a vanity (not a pedestal), regular size toilet, a tub and a shower. My basement design was for a full bathroom.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |